Hyundai 22212-23600 Valve-Exhaust

You can Select Your Vehicle to check if 22212-23600 fits your vehicle.

After the valve job has been performed by a professional, the head will be in like new condition. When the head is returned, it should be cleaned again before installation on the engine to remove any metal particles and abrasive grit that may still be present from the valve service or head resurfacing operations. It is recommended to use compressed air, if available, to blow out all the oil holes and passages.

To check and adjust the valve clearance on 2.0L models, follow these steps: Remove the engine cover and spark plug wires. Blow out the spark plug openings and remove the spark plugs. Remove the valve cover and upper timing belt cover. Position the number 1 piston at TDC on the compression stroke. Measure the clearances of the indicated valves with feeler gauges and record out-of-spec measurements. Turn the crankshaft one complete revolution and measure the remaining valves. With the camshaft lobe above the first valve to be adjusted pointing upward, depress the lifter with a special lifter tool. Remove the adjusting shim and measure its thickness with a micrometer. Calculate the correct thickness of a replacement shim using a formula. Select a shim with a thickness as close as possible to the calculated valve clearance. Install the shim into position using a light coat of motor oil for lubrication. Recheck the valve clearances. Reinstall the valve cover, spark plugs, and other components.