Hyundai 57100-3K010 Pump Assembly-Power Steering Oil

You can Select Your Vehicle to check if 57100-3K010 fits your vehicle.

Before starting the removal of the power steering pump, the cable of the negative terminal of the battery should be disconnected. Then, tension the large syringe or suction gun and try to get as much fluid as you can from the power steering fluid reservoir, considering using a drain pan to collect the fluid in case some of it spills when disconnecting the hoses. Take off the drivebelt, after that, liberate the fluid suction hose from the pump and disconnect the connector of the power steering pressure switching power. Remove the sealing washers of the pressure line and on the side of the pump also remove the pressure switch. Last, you have to take out the mounting bolts and then, raise the power steering pump from its position. Finally for removal, reverse the installation procedures, but when tightening the mounting bolts of the Savior valve, one ought to tighten unto the specified torque as well as apply new sealing washers on the pressure line fitting. After the installation of the system, add the required amount of fluid in the reservoir and also perform a bleed.