Hyundai 21510-38052 Pan Assembly-Engine Oil,Lower

You can Select Your Vehicle to check if 21510-38052 fits your vehicle.

Use a scraper to remove all traces of old sealant from the block and oil pan, and clean the mating surfaces with lacquer thinner or acetone.

Remove any interfering components. The oil pan has two parts: an upper cast section and a lower section made of stamped steel. Remove the lower oil pan now.

19. Clean all sealing surfaces thoroughly with brake system cleaner to remove all traces of oil. 20. Inspect the oil pump pick-up/strainer assembly for cracks and blockages, clean it, and install it using a new gasket. 21. Apply a 3/16-inch wide bead of RTV sealant to the aluminum pan section, ensuring the pan is installed within five minutes. 22. Position the pan on the engine block and install the bolts, tightening them to the specified torque and following the tightening sequence. 23. The remainder of the installation is the reverse of removal. Allow the sealant to set for at least two hours before adding new oil and a new oil filter. 24. Run the engine and check for oil pressure and leaks.

Drain the engine oil and remove the oil filter (see Chapter 1). Remove the oil dipstick.