Hyundai 37300-37250 Generator Assembly

You can Select Your Vehicle to check if 37300-37250 fits your vehicle.

Removal begins with disconnecting the cable from the negative battery terminal. For 1999 through 2005 four-cylinder models, disconnect the electrical connectors from the alternator, loosen the lock bolt on the upper alternator adjusting mount and the lower mount bolt. Turn the adjusting bolt counterclockwise to release tension on the drivebelt, then remove the drivebelt. Remove the two alternator mounting bolts and remove the alternator. For all other models, remove the drivebelt. Access is very limited on these models. It will be necessary to remove various components including the lower engine splash shield to gain access. These components vary from model to model. Disconnect the electrical connectors from the alternator and air conditioning compressor, then move the harness out of the way. On 2011 and later 2.4L engines, remove the Variable Intake Solenoid (VIS) actuator and valve. Remove the mounting bolts and remove the alternator. For installation, if you're replacing the alternator, take the old alternator with you when purchasing a replacement unit. Make sure that the new/ rebuilt unit is identical to the old alternator. Look at the terminals - they should be the same in number, size and locations as the terminals on the old alternator. Finally, look at the identification markings - they will be stamped in the housing or printed on a tag or plaque affixed to the housing. Make sure that these numbers are the same on both alternators. If the replacement alternator doesn't have a pulley installed, you may have to switch the pulley from the old unit to the replacement unit. When buying a new or rebuilt alternator, ask about the shop's policy regarding pulley swapping. Some shops will perform this service for free. Installation is the reverse of removal. After the alternator is installed, adjust the drivebelt tension, then check the charging voltage to verify that the alternator is operating correctly.

Before installing a new alternator, it is recommended to take the old alternator with you when purchasing a replacement unit. Make sure that the new/rebuilt unit is identical to the old alternator. Look at the terminals - they should be the same in number, size, and locations as the terminals on the old alternator. Also, check the identification markings on the housing or tag to ensure they match. If the replacement alternator does not have a pulley installed, you may need to switch the pulley from the old unit to the replacement unit. Inquire about the shop's policy regarding pulley swapping when buying a new or rebuilt alternator.