Hyundai 95550-1E000 Flasher Module-Turn Signal

You can Select Your Vehicle to check if 95550-1E000 fits your vehicle.

The turn signal/hazard flasher, which is a black plastic canister probably about 3 and a half inches high attached to the wiring harness under the dashboard, is for flashlighting the turn signals. In addition to this, it should be noted that when working without any complications, it is possible to hear a clicking sound. When the turn signals of one side go off and the flasher unit does not make the famous clicking sound, that implies a bad turn signal bulb. If both turn signals fail to function and blink, then it is caused by a bad output flasher, bad switch, bad fusible link, or an open or shorted turn signal switch. It is possible for the turn signal fuse to have gone off and this may be discovered just by a look at the fuse box and before replacing the fuse, one should check the wiring whether it has a short circuit. On the models of the year 2005 and earlier, the turn signal/hazard flasher is situated on the interior fuse and relay box place that is situated under the left end of the dash which means the kick panel has to be removed.

Some relays may be marked to help identify the control circuit and power circuit terminals. If the relay is not marked, further testing is required.

Disconnect the electrical connectors, then remove the mounting nuts and bolts.

Most relays are marked to help determine which terminals are the control circuit and which are the power circuit.