Hyundai 43760-24705 Automatic Transmission Lever Cable Assembly

You can Select Your Vehicle to check if 43760-24705 fits your vehicle.

To remove the shift cable assembly, first disconnect the negative cable from the battery and, for carbureted models, remove the air cleaner assembly. In the engine compartment, disconnect the shift cable at the bracket and transaxle lever, noting the differences in attachment methods between 1989 and earlier models and 1990 and later models. Raise the vehicle and support it securely on jackstands, then remove the shift cable assembly mounting bolt and nuts from underneath. Next, remove the selector lever assembly mounting nuts, and inside the vehicle, take out the handle set screw or screws depending on the model year. For earlier models, grasp the selector lever handle, press the lockout button, and pull up sharply to remove it; for later models, disconnect the overdrive switch connector, drive out the connector pins, and then remove the handle. Remove the shift lever indicator and center console, disconnect the shift cable, and take out the selector lever assembly. To install, place the selector lever assembly and secure the mounting nuts, then install the shift cable and connect it to the firewall, transaxle, and selector lever, ensuring the toothed washer is correctly positioned for 1994 and earlier models. For adjustment, place the selector lever in Neutral and turn the lever adjusting sleeve to achieve the specified sleeve-to-lever end clearance, ensuring the angled surface faces the driver's side after adjustment, and apply a small amount of multi-purpose grease. Install the console and selector lever handle, eliminate any slack in the shift cable if necessary, and check the operation of the transaxle in each selector lever position, ensuring the starter operates only in Park and Neutral, adjusting the Neutral start switch if needed.