Hyundai 98350-26800 Windshield Wiper Blade Assembly

You can Select Your Vehicle to check if 98350-26800 fits your vehicle.

The elements of the wiper and blade assembly which are windshield should be regularly assessed for broken parts, loose components, and if cracked or worn out. Therefore, wipers need to be washed with a mild detergent on a regular basis since road films may accumulate on them resulting in their ineffective operation. As the wiping mechanism moves back and forth it can become loose causing bolts nuts and fasteners. Accordingly, when examining the condition of the wiper blades any necessary tightening of these must also take place at that time. The only solution in case the blades have been warped, worn or damaged is replacing them with new ones. Raise the arm assembly above the glass to clear then press down on release lever before pulling back entire wiper blade assembly out from end hook of arm. Thus to separate it from this arm you must push onto release pin and pull backwards on it so as to remove it while making sure not touch your finger's sharp edge to avoid injuries. Attach new wiper blade unit to this one's insides as guided by an audible click sound telling you that connection has finally been made through this step by step process!

Periodically, check the windshield wiper and blade assembly for harm, loose parts, as well as cracked or worn blade components. Film coating can collect on the wipers and compromise their efficacy; hence they should be cleaned using a mild detergent solution. The action of wiping may loosen bolts, nuts, and fasteners; therefore, it is advisable to tighten them whenever blades are checked. Replace them if the blade elements are cracked, worn out or bent and no longer clean properly. Take away the arm assembly from the glass so that it does not touch anything when being released then push down on the release lever while sliding off the wiper blade assembly from its hook at the tip of the arm. At this point insert can be installed into arm as well as removing it out by just pulling one end of it out with your fingers for replacement purposes alone. Attach now one of these blades to an arm whereby connection will be demonstrated through hearing a click sound as a confirmation.